Home page

Hengxing PVC anticorrosive gutter-Polymer structure-Water and drainage without delay

Release time:

2017-03-09

Heng Xing PVC anticorrosive polymer structure gutter takes PVC resin as the main raw material, collocation certain function assistant, after extrusion molding, it is the renewal substitute of iron flume, iron plate sink and glass fiber reinforced plastic tank.

This product has the advantages of flame-retardant, anticorrosion, portability, durability, high strength, acid resistance and alkali resistance, easy construction and so on. It can be widely used in drainage engineering of factory shed or steel structure workshop, warehouse, market and so on.

Hengxing PVC gutterfittings gutterflat seal: add seal at the end of the sink, make the whole sink more perfect, the appearance is more beautiful.

gutterflat connection: connect between trough body, convenient and fast.

Sealant with sealer: combine the seal with the sewer, convenient and easy to install, save money and material.

Features of water interface: connecting sink, falling in the middle, flexible collocation.

1、When installing the flume, the bottom support shall be made of iron and steel, and the base shall be in a straight line and 1.There is a supporting place within 8 meters.The sides of the sink shall be protected by an iron frame.

2、the two ends of the sink connection or connection should be supported by a bracket.

As shown below, there are two supporting points.

3、do not open holes in the tank body drainage, this will affect the service life of the sink, need special drainage fittings and pipes connected to the sewer.

4、the drainage outlet should be matched, it is recommended that every 6 meters to set up a drain.

5、The whole gutter shall be installed not more than 18 m. If it must be exceeded, the installation and drainage shall be carried out in sections.